Plywood (less than 1-1/8 inch thick) or OSB

Each Safety Boot® installed must use:
4--Hex Head Lag Screws, 3/8 x 3 inch; and
4--3/8 X 1-1/2 inch Fender Washers
Washers Provided with ALL Orders

Anchor through the plywood or OSB into floor joists or solid 2X lumber blocking on the underside of subfloor using the four primary corner holes.

 

Warning! Never Use Nails or Unspecified Fasteners to Anchor the Safety Boot®!

Different Types of Subfloor Material Require Different Types of Fasteners In Order to Exceed the OH&S Guardrail Requirements.

Securing Safety Boot® to 2X4 Post

Each Safety Boot® must use:

1--Hex-Head Lag Screw, 3/8 x 2 inch; and
1--3/8 X 1-1/2 inch Fender Washer

Washers Provided with ALL Orders

Anchor into provided hole in sidewall of Safety Boot®.